AGA eR7 range
showing 130-136
Codes 130 to 136 are triac errors: the solid-state switch that powers an element has seen something wrong in that circuit.
Mon–Sat, 8am–8pm
- Oven heating
- Bake and broil elements
- Source: AGA
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What 130-136
actually means.
Codes 130 to 136 are triac errors: the solid-state switch that powers an element has seen something wrong in that circuit. The technician measures the element, which should read 18 to 20 ohms, and replaces it if it is open; if the element is fine and the software is current, the main board is changed.
AGA range display
What to do when 130-136 shows on the rangeKind of codeOven heating
The oven under the burners called for heat and the cavity did not warm the way the control planned. On an electric oven a bake or broil element that has burned open is the usual cause; on a gas oven the igniter and the valve it opens come first. The wiring and the relay are checked before the board takes the blame.
Usually leads toBake and broil elements
An electric range oven that stays cold, heats only from above or below, or will not broil, traced to the elements, their terminals or the relay that switches them.
Shows up asRange Error Code
The range display shows letters, numbers or a flashing symbol, beeps, and stops the oven, a cooking zone or a clean.
MakeAGA
A British cooking name, owned by Middleby, that sells cast-iron heat-storage cookers and more conventional dual-fuel and induction ranges in the US.
SourceAGA eR7 Field Service Manual, USA and Canada
eR7 ranges; the boiling and simmer plates share one 2.5 kW circular element design and the ovens a 2.5 kW rectangular one.
Before you book,
in this order.
Each step comes from AGA's own guidance for 130-136 on its ranges. Follow it to the end: the last card says whether this is a visit.
Note the number and which hotplate or oven stopped heating.
Book a visit so the element and its connections can be measured.
What not to do
A triac code does not prove the board has failed. An element that has gone open or a loose terminal produces the same code.
What you may
notice with it.
The range problems 130-136 tends to arrive with. Answer these at the range before anyone is booked.
All problems
Range Error Code
6 causes, cheapest first
Where 130-136 usually leads
Bake and broil elements.
AGA
ranges.
A British cooking name, owned by Middleby, that sells cast-iron heat-storage cookers and more conventional dual-fuel and induction ranges in the US.
AGA range repair
Electric range
Coil elements or radiant elements under a smooth glass top, with an electric oven below, all running on a dedicated 240-volt circuit.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In AGA's own words
Triac Fault - Check connections of element circuit showing a triac error at element terminals
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. eR7 ranges; the boiling and simmer plates share one 2.5 kW circular element design and the ovens a 2.5 kW rectangular one.
AGA 130-136 range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about 130-136.
Can I clear 130-136 myself?
Which part usually fixes 130-136 on an AGA eR7?
Can 130-136 affect an AGA eR7 hotplate?
Back to your everyday
Still showing 130-136?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.