The underside of a range's control panel tipped forward with its cover off, a flat ribbon cable running from the display to the main board.

AGA eR7 range
showing 110-116

The main board switches each element through relays, and 110 to 116 means one of them is stuck in a shorted state.

(844) 875-7576

Mon–Sat, 8am–8pm

  • Controls and communication
  • Knobs, switches and controls
  • Source: AGA

Book a visit

Three short steps, about a minute.

or call (844) 875-7576

Before you book,
in this order.

Each step comes from AGA's own guidance for 110-116 on its ranges. Follow it to the end: the last card says whether this is a visit.

01

Record the number and roughly when it appeared.

02

Book a visit for the board reset; if the relay code comes back, the main board is replaced.

Still there?

It usually turns into knobs, switches and controls. Book with the code and the model number.

What not to do

This is not an element or sensor code. The part at issue is the switch on the board, not the heater it feeds.

What you may
notice with it.

The range problems 110-116 tends to arrive with. Answer these at the range before anyone is booked.

All problems

Where 110-116 usually leads

Knobs, switches and controls.

Knobs, keypad or control board · moderate.

In AGA's own words

110 - 116: Relay short circuit - Reset PCB and Log. If recurring then PCB may be required.
AGA eR7 Field Service Manual, USA and Canada AGA eR7 Field Service Manual, USA and Canada AGA eR7 Field Service Manual, USA and Canada

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. eR7 ranges; the main board sits in the base of the cooker.

AGA 110-116 range repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child stirring a pot on a gas range together in a bright kitchen
For the heart of your home.

Questions
about 110-116.

Can I clear 110-116 myself?
Record the number and roughly when it appeared. If it comes back, it needs a visit.
Can I clear a relay code on my AGA eR7 myself?
No. AGA's step is a logged reset on the main board, and its manual says owners should not be taught that reset, so it is done during a visit.
Does 110-116 on an AGA eR7 always mean a new main board?
Not on the first occurrence. AGA resets and logs it, and the board is replaced only if the code returns.

Back to your everyday

Still showing 110-116?

Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.

(844) 875-7576 Schedule a repair