AGA eR7 range
showing 060-100
Codes from 060 to 100 report an open thermocouple circuit, meaning the panel sees no signal from one of a zone's sensors.
Mon–Sat, 8am–8pm
- Temperature sensor
- Temperature sensor and thermostat repair
- Source: AGA
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What 060-100
actually means.
Codes from 060 to 100 report an open thermocouple circuit, meaning the panel sees no signal from one of a zone's sensors. The probe may have failed, or its plug may not be fully seated behind the user panel.
AGA range display
What to do when 060-100 shows on the rangeKind of codeTemperature sensor
The oven sensor sent a reading the control would not accept, or one that climbed well past the setting. A loose plug or a sensor that has drifted is ruled out before the control board, and a temperature that keeps rising means the range is switched off at the breaker first.
Usually leads toTemperature sensor and thermostat repair
A range oven that bakes hot, bakes slow, takes forever to preheat or posts a sensor code, traced to the sensor probe, the thermostat or the calibration.
Shows up asRange Error Code
The range display shows letters, numbers or a flashing symbol, beeps, and stops the oven, a cooking zone or a clean.
MakeAGA
A British cooking name, owned by Middleby, that sells cast-iron heat-storage cookers and more conventional dual-fuel and induction ranges in the US.
SourceAGA eR7 Field Service Manual, USA and Canada
eR7 ranges; each thermocouple plug carries four wires, one green and one white per sensor.
Before you book,
in this order.
Each step comes from AGA's own guidance for 060-100 on its ranges. Follow it to the end: the last card says whether this is a visit.
Write down the number the handset shows.
Book a visit; the technician tests each pair of wires on the four-wire plug and checks it is pushed fully home.
Still there?
It usually turns into temperature sensor and thermostat repair. Book with the code and the model number.
What not to do
Turning the range off at the breaker will not clear a zone that has locked on this code; the reset is done on the main board during service.
What you may
notice with it.
The range problems 060-100 tends to arrive with. Answer these at the range before anyone is booked.
All problems
Range Error Code
6 causes, cheapest first
Where 060-100 usually leads
Temperature sensor and thermostat repair.
AGA
ranges.
A British cooking name, owned by Middleby, that sells cast-iron heat-storage cookers and more conventional dual-fuel and induction ranges in the US.
AGA range repair
Electric range
Coil elements or radiant elements under a smooth glass top, with an electric oven below, all running on a dedicated 240-volt circuit.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In AGA's own words
T/Couple open circuit - Check the thermocouple with a multimeter.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. eR7 ranges; each thermocouple plug carries four wires, one green and one white per sensor.
AGA 060-100 range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about 060-100.
Can I clear 060-100 myself?
Could 060-100 on my AGA eR7 be just a loose plug?
Will the affected zone on my AGA eR7 work while 060-100 is logged?
Back to your everyday
Still showing 060-100?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.