Electrolux range
showing F30
Electrolux names F30 an open probe and F31 a shorted probe.
Mon–Sat, 8am–8pm
- Temperature sensor
- Temperature sensor and thermostat repair
- Source: Electrolux
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F30
actually means.
Electrolux names F30 an open probe and F31 a shorted probe. In both cases the reading from the probe circuit makes no sense to the control.
Electrolux range display · also shown as F31
What to do when F30 shows on the rangeKind of codeTemperature sensor
The oven sensor sent a reading the control would not accept, or one that climbed well past the setting. A loose plug or a sensor that has drifted is ruled out before the control board, and a temperature that keeps rising means the range is switched off at the breaker first.
Usually leads toTemperature sensor and thermostat repair
A range oven that bakes hot, bakes slow, takes forever to preheat or posts a sensor code, traced to the sensor probe, the thermostat or the calibration.
Shows up asRange Oven Temperature Wrong
Recipes burn or come out underdone, and an oven thermometer disagrees with the temperature set on the range.
MakeElectrolux
A Swedish appliance group whose US ranges are front-control models in gas, electric and induction versions.
SourceElectrolux "Range Error Code F30 - Open Probe"
Electrolux lists F30 for its electric ranges without naming models, and the ECF freestanding ranges print Err rather than F-codes.
Before you book,
in this order.
Each step comes from Electrolux's own guidance for F30 on its ranges. Follow it to the end: the last card says whether this is a visit.
Remove and reseat the food probe if your model has one.
Cut power for about 30 seconds at the breaker.
Book a visit if the code comes back.
Still there?
It usually turns into temperature sensor and thermostat repair. Book with the code and the model number.
What not to do
These codes are about the probe reading, not the oven running too hot.
What you may
notice with it.
The range problems F30 tends to arrive with. Answer these at the range before anyone is booked.
All problems
Range Oven Temperature Wrong
5 causes, cheapest first
Where F30 usually leads
Temperature sensor and thermostat repair.
Electrolux
ranges.
A Swedish appliance group whose US ranges are front-control models in gas, electric and induction versions.
Electrolux range repair
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In Electrolux's own words
Electric Range Error Code F30 - Open Probe
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Electrolux lists F30 for its electric ranges without naming models, and the ECF freestanding ranges print Err rather than F-codes.
Electrolux F30 range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F30.
Can I clear F30 myself?
Is the probe in F30 the meat probe on my Electrolux range?
Why did F31 appear after I cleaned my Electrolux oven?
Back to your everyday
Still showing F30?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.