ZLINE induction range
showing E/5
E/5 reports that the temperature sensor on an induction coil is disconnected or has moved out of position.
Mon–Sat, 8am–8pm
- Temperature sensor
- Temperature sensor and thermostat repair
- Source: ZLINE
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E/5
actually means.
E/5 reports that the temperature sensor on an induction coil is disconnected or has moved out of position. ZLINE's remedy is service to reposition the sensor or replace it.
ZLINE range display · also shown as E5
What to do when E/5 shows on the rangeKind of codeTemperature sensor
The oven sensor sent a reading the control would not accept, or one that climbed well past the setting. A loose plug or a sensor that has drifted is ruled out before the control board, and a temperature that keeps rising means the range is switched off at the breaker first.
Usually leads toTemperature sensor and thermostat repair
A range oven that bakes hot, bakes slow, takes forever to preheat or posts a sensor code, traced to the sensor probe, the thermostat or the calibration.
Shows up asRange Error Code
The range display shows letters, numbers or a flashing symbol, beeps, and stops the oven, a cooking zone or a clean.
MakeZLINE
An American company, ZLINE Kitchen and Bath, selling professional-style gas, dual-fuel and induction ranges.
SourceZLINE Induction Ranges User Manual
Listed for the MINR and SINR induction ranges alongside F/3, the other coil-sensor code.
Before you book,
in this order.
Each step comes from ZLINE's own guidance for E/5 on its ranges. Follow it to the end: the last card says whether this is a visit.
Leave the affected zone off.
Book a visit so the sensor can be reseated or changed.
Still there?
It usually turns into temperature sensor and thermostat repair. Book with the code and the model number.
What not to do
E/5 is not an overheating code; the sensor is simply not where it should be.
What you may
notice with it.
The range problems E/5 tends to arrive with. Answer these at the range before anyone is booked.
All problems
Range Error Code
6 causes, cheapest first
Where E/5 usually leads
Temperature sensor and thermostat repair.
ZLINE
ranges.
An American company, ZLINE Kitchen and Bath, selling professional-style gas, dual-fuel and induction ranges.
ZLINE range repair
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In ZLINE's own words
E/5 – Coil Temperature Sensor (NTC) Disconnected / Moved
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed for the MINR and SINR induction ranges alongside F/3, the other coil-sensor code.
ZLINE E/5 range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E/5.
Can I clear E/5 myself?
Can E/5 on a ZLINE be fixed without new parts?
What moves a coil sensor on a ZLINE induction range?
Back to your everyday
Still showing E/5?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.