ZLINE induction range
showing E/4
E/4 is undervoltage protection: the supply reaching the range is below the level it needs to run safely.
Mon–Sat, 8am–8pm
- Controls and communication
- Knobs, switches and controls
- Source: ZLINE
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E/4
actually means.
E/4 is undervoltage protection: the supply reaching the range is below the level it needs to run safely. ZLINE asks owners not to use the induction top until the voltage is stable.
ZLINE range display · also shown as E4
What to do when E/4 shows on the rangeKind of codeControls and communication
The display, the main board or the induction power board lost contact with one another, or one of them failed its own self-check. A power dip, a loose cable or moisture from a boil-over is ruled out before a board is replaced, and a range that keeps heating while this code shows is switched off at the breaker.
Usually leads toKnobs, switches and controls
Knobs that spin or crack, touch keys that do nothing, blank displays, clocks that reset and control boards that switch the wrong thing.
Shows up asRange Error Code
The range display shows letters, numbers or a flashing symbol, beeps, and stops the oven, a cooking zone or a clean.
MakeZLINE
An American company, ZLINE Kitchen and Bath, selling professional-style gas, dual-fuel and induction ranges.
SourceZLINE Induction Ranges User Manual
ZLINE MINR and SINR induction models; E/4 is the low-voltage counterpart of E/3.
Before you book,
in this order.
Each step comes from ZLINE's own guidance for E/4 on its ranges. Follow it to the end: the last card says whether this is a visit.
Stop cooking on the induction zones for now.
Have the supply checked by an electrician if E/4 continues, and book a visit if it shows on a verified supply.
Still there?
It usually turns into knobs, switches and controls. Book with the code and the model number.
What not to do
E/4 does not point to a failed board or coil; the range is reacting to what it receives.
What you may
notice with it.
The range problems E/4 tends to arrive with. Answer these at the range before anyone is booked.
All problems
Range Error Code
6 causes, cheapest first
Where E/4 usually leads
Knobs, switches and controls.
ZLINE
ranges.
An American company, ZLINE Kitchen and Bath, selling professional-style gas, dual-fuel and induction ranges.
ZLINE range repair
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In ZLINE's own words
E/4 – Undervoltage Protection Input voltage is too low for safe operation.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. ZLINE MINR and SINR induction models; E/4 is the low-voltage counterpart of E/3.
ZLINE E/4 range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E/4.
Can I clear E/4 myself?
Who checks the supply when my ZLINE induction range shows E/4?
Does E/4 damage my ZLINE induction range?
Back to your everyday
Still showing E/4?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.