The underside of a range's control panel tipped forward with its cover off, a flat ribbon cable running from the display to the main board.

AGA eR7 range
showing 150-156

The 150 to 156 group is a relay open circuit: a relay the board uses to power an element stays open, so that zone gets no power.

(844) 875-7576

Mon–Sat, 8am–8pm

  • Controls and communication
  • Knobs, switches and controls
  • Source: AGA

Book a visit

Three short steps, about a minute.

or call (844) 875-7576

Before you book,
in this order.

Each step comes from AGA's own guidance for 150-156 on its ranges. Follow it to the end: the last card says whether this is a visit.

01

Note the number and which zone went cold.

02

Book a visit for the reset and, if needed, the board.

Still there?

It usually turns into knobs, switches and controls. Book with the code and the model number.

What not to do

The element itself may be fine; the switch feeding it is what the code describes.

What you may
notice with it.

The range problems 150-156 tends to arrive with. Answer these at the range before anyone is booked.

All problems

Where 150-156 usually leads

Knobs, switches and controls.

Knobs, keypad or control board · moderate.

In AGA's own words

150 - 156: Relay Open Circuit - Reset and Log. If recurring then PCB may be required.
AGA eR7 Field Service Manual, USA and Canada

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. eR7 ranges; relay codes sit in their own group separate from triac and element codes.

AGA 150-156 range repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child stirring a pot on a gas range together in a bright kitchen
For the heart of your home.

Questions
about 150-156.

Can I clear 150-156 myself?
Note the number and which zone went cold. If it comes back, it needs a visit.
How is 150-156 different from 110-116 on an AGA eR7?
Both concern relays on the main board: 110-116 reports a relay shorted, while 150-156 reports one stuck open so its zone gets no power.
Will my AGA eR7 zone come back after a 150-156 reset?
It may. If the code returns afterward, the main board is the part AGA points to.

Back to your everyday

Still showing 150-156?

Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.

(844) 875-7576 Schedule a repair