BlueStar Platinum induction range
showing Er47
Er47 is listed in BlueStar's induction table as a system issue on the range top of a Platinum induction range.
Mon–Sat, 8am–8pm
- Controls and communication
- Knobs, switches and controls
- Source: BlueStar
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Er47
actually means.
Er47 is listed in BlueStar's induction table as a system issue on the range top of a Platinum induction range. BlueStar does not break it down further, and treats any other E code the same way.
BlueStar range display · also shown as Er 47
What to do when Er47 shows on the rangeKind of codeControls and communication
The display, the main board or the induction power board lost contact with one another, or one of them failed its own self-check. A power dip, a loose cable or moisture from a boil-over is ruled out before a board is replaced, and a range that keeps heating while this code shows is switched off at the breaker.
Usually leads toKnobs, switches and controls
Knobs that spin or crack, touch keys that do nothing, blank displays, clocks that reset and control boards that switch the wrong thing.
Shows up asRange Surface Element Not Heating
One coil or glass-top zone on an electric range stays cold, heats only weakly, or will not respond while the others work.
MakeBlueStar
A Pennsylvania company that builds professional-style gas and dual-fuel ranges, known for open burners and a very wide choice of finishes.
SourceBlueStar Platinum induction range manual 100799, induction indicators
BlueStar BSPIR Platinum induction ranges. Other E codes not named in the manual are grouped as induction system issues.
Before you book,
in this order.
Each step comes from BlueStar's own guidance for Er47 on its ranges. Follow it to the end: the last card says whether this is a visit.
Turn the zones off and write down the code exactly as it appears.
If Er47 returns, book a visit and give the exact code.
Still there?
It usually turns into knobs, switches and controls. Book with the code and the model number.
What not to do
Er47 does not concern the pan or the voltage; BlueStar gives those their own indicators.
What you may
notice with it.
The range problems Er47 tends to arrive with. Answer these at the range before anyone is booked.
All problems
Where Er47 usually leads
Knobs, switches and controls.
BlueStar
ranges.
A Pennsylvania company that builds professional-style gas and dual-fuel ranges, known for open burners and a very wide choice of finishes.
BlueStar range repairMore BlueStar codes
Controls and communication on other makes
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In BlueStar's own words
Er47 is displayed
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. BlueStar BSPIR Platinum induction ranges. Other E codes not named in the manual are grouped as induction system issues.
BlueStar Er47 range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Er47.
Can I clear Er47 myself?
What part does Er47 on a BlueStar induction range involve?
My BlueStar shows an E code that is not in the manual. Is it the same as Er47?
Back to your everyday
Still showing Er47?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.