SKS gas slide-in range
showing Loc
Loc is the Lock Out feature on the SKS gas slide-in.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: SKS
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Loc
actually means.
Loc is the Lock Out feature on the SKS gas slide-in. It locks the oven door and stops most oven and burner controls from turning on, while the timer and oven light still work; it is set and cleared by holding Probe for three seconds with the mode knob at Off.
SKS range display
What to do when Loc shows on the rangeKind of codeMode, not a failure
Something the range was told to do, or a state it chose on purpose — a control lock, a Sabbath setting, a demo mode that lights the display but never heats, a pan warning on an induction zone. Nothing has worn out, and no part is needed.
Usually leads toNo repair
Set the oven mode knob to Off and press and hold Probe for three seconds to release Lock Out.
Shows up asRange Control Panel Not Responding
The touch keys or knobs on the range do nothing, only some keys work, the display is blank or frozen, or it beeps without starting.
MakeSKS
Signature Kitchen Suite, LG's luxury built-in brand, selling professional-style dual-fuel and induction ranges.
SourceSKS UPSG3014ST owner's manual
Lock Out and its Loc display are described in the UPSG3014ST gas slide-in manual.
Before you book,
in this order.
Each step comes from SKS's own guidance for Loc on its ranges. Follow it to the end: the last card says whether this is a visit.
Set the oven mode knob to Off and press and hold Probe for three seconds to release Lock Out.
After a self-clean, allow up to an hour for the door to unlock as the oven cools.
Cleared?
The range was set right without a new part. If the same message comes back while a burner or the oven is in use, or the range cuts out again, treat it as a new problem and book it.
What not to do
Loc is not a failed latch. A door that stays locked long after the oven is cold is the case for a visit.
What you may
notice with it.
The range problems Loc tends to arrive with. Answer these at the range before anyone is booked.
All problems
No repair indicated
Nothing to repair.
Something the range was told to do, or a state it chose on purpose — a control lock, a Sabbath setting, a demo mode that lights the display but never heats, a pan warning on an induction zone. Nothing has worn out, and no part is needed.
SKS
ranges.
Signature Kitchen Suite, LG's luxury built-in brand, selling professional-style dual-fuel and induction ranges.
SKS range repairMore SKS codes
Mode, not a failure on other makes
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In SKS's own words
The Lock Out feature automatically locks the oven door and prevents most oven and cooktop controls from being turned on.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Lock Out and its Loc display are described in the UPSG3014ST gas slide-in manual.
SKS Loc range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Loc.
Can I clear Loc myself?
Why can't I light the burners on my SKS slide-in while Loc shows?
My SKS door stays locked after self-clean. Is that Loc?
Back to your everyday
Still showing Loc?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.