KitchenAid commercial-style range with a blinking Start button
On KitchenAid's commercial-style ranges, steady white controls with a flashing Start button and no heat usually mean Start was pressed before it began to flash.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: KitchenAid
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Blinking Start button
actually means.
On KitchenAid's commercial-style ranges, steady white controls with a flashing Start button and no heat usually mean Start was pressed before it began to flash. White blinking also shows while the oven climbs to a temperature you just raised.
KitchenAid range display
What to do when Blinking Start button shows on the rangeKind of codeMode, not a failure
Something the range was told to do, or a state it chose on purpose — a control lock, a Sabbath setting, a demo mode that lights the display but never heats, a pan warning on an induction zone. Nothing has worn out, and no part is needed.
Usually leads toNo repair
Turn the Mode knob to another position and the Temp knob back to Off.
Shows up asRange Oven Not Heating
The burners or elements on top work, but the oven below stays cold, heats only a little, or never finishes preheating.
MakeKitchenAid
A Whirlpool Corporation brand with slide-in and freestanding ranges in gas, electric, dual-fuel and induction versions.
SourceKitchenAid product help: commercial-style range lights and codes
KitchenAid commercial-style ranges with knob controls and a Start button.
Before you book,
in this order.
Each step comes from KitchenAid's own guidance for Blinking Start button on its ranges. Follow it to the end: the last card says whether this is a visit.
Turn the Mode knob to another position and the Temp knob back to Off.
Choose the mode and temperature again, wait for Start to flash, then press it.
Cleared?
The range was set right without a new part. If the same message comes back while a burner or the oven is in use, or the range cuts out again, treat it as a new problem and book it.
What not to do
White blinking is not an error signal; KitchenAid uses amber lights for that.
What you may
notice with it.
The range problems Blinking Start button tends to arrive with. Answer these at the range before anyone is booked.
All problems
Range Oven Not Heating
7 causes, cheapest first
No repair indicated
Nothing to repair.
Something the range was told to do, or a state it chose on purpose — a control lock, a Sabbath setting, a demo mode that lights the display but never heats, a pan warning on an induction zone. Nothing has worn out, and no part is needed.
KitchenAid
ranges.
A Whirlpool Corporation brand with slide-in and freestanding ranges in gas, electric, dual-fuel and induction versions.
KitchenAid range repairMore KitchenAid codes
Mode, not a failure on other makes
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Electric range
Coil elements or radiant elements under a smooth glass top, with an electric oven below, all running on a dedicated 240-volt circuit.
Dual-fuel range
Gas burners on top and an electric oven below, the combination most professional-style ranges use, needing both a gas line and a 240-volt circuit.
In KitchenAid's own words
this usually means the "Start" button was pressed too soon (before it was flashing).
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. KitchenAid commercial-style ranges with knob controls and a Start button.
KitchenAid Blinking Start button range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Blinking Start button.
Can I clear Blinking Start button myself?
Why won't my KitchenAid commercial-style oven start when I press Start?
Is a solid lit Start button the same thing on a KitchenAid?
Back to your everyday
Still showing Blinking Start button?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.