Kenmore induction range
showing H
On the Kenmore 982.9685 induction range, H by a cooking zone means the glass above it is still too hot to touch.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Kenmore
Book a visit
Three short steps, about a minute.
or call (844) 875-7576
Loading appointment form…
The appointment form couldn’t load. Please try again.
What H
actually means.
On the Kenmore 982.9685 induction range, H by a cooking zone means the glass above it is still too hot to touch. The pan heats the glass, so the zone stays warm for a while after cooking.
Kenmore range display
What to do when H shows on the rangeKind of codeMode, not a failure
Something the range was told to do, or a state it chose on purpose — a control lock, a Sabbath setting, a demo mode that lights the display but never heats, a pan warning on an induction zone. Nothing has worn out, and no part is needed.
Usually leads toNo repair
Leave the zone alone until the H disappears.
Shows up asRange Surface Element Not Heating
One coil or glass-top zone on an electric range stays cold, heats only weakly, or will not respond while the others work.
MakeKenmore
A Sears store brand whose ranges were built for it by other appliance manufacturers.
SourceKenmore Use & Care Guide, induction range 982.9685#
Kenmore induction range model 982.9685#, sold as model 22-96853 on Kenmore's site.
Before you book,
in this order.
Each step comes from Kenmore's own guidance for H on its ranges. Follow it to the end: the last card says whether this is a visit.
Leave the zone alone until the H disappears.
If H stays on long after the glass is cold, book a visit.
Cleared?
The range was set right without a new part. If the same message comes back while a burner or the oven is in use, or the range cuts out again, treat it as a new problem and book it.
What not to do
H is not a sign that the zone is still switched on.
What you may
notice with it.
The range problems H tends to arrive with. Answer these at the range before anyone is booked.
All problems
No repair indicated
Nothing to repair.
Something the range was told to do, or a state it chose on purpose — a control lock, a Sabbath setting, a demo mode that lights the display but never heats, a pan warning on an induction zone. Nothing has worn out, and no part is needed.
Kenmore
ranges.
A Sears store brand whose ranges were built for it by other appliance manufacturers.
Kenmore range repairMore Kenmore codes
Mode, not a failure on other makes
Gas range
Open flames on top and a gas-fired oven below, all fed by one supply line behind the range and lit by igniters rather than a match.
Electric range
Coil elements or radiant elements under a smooth glass top, with an electric oven below, all running on a dedicated 240-volt circuit.
Induction range
A glass top that heats the pan itself through copper coils and power boards, over an electric oven, with electronics doing almost all the work.
In Kenmore's own words
“H” is the cooking zone is too hot to touch. It will disappear when
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Kenmore induction range model 982.9685#, sold as model 22-96853 on Kenmore's site.
Kenmore H range repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about H.
Can I clear H myself?
Why does my Kenmore induction zone still show H after I turn it off?
Should H worry me on a Kenmore induction range?
Back to your everyday
Still showing H?
Book with the code exactly as it appears, the full model number, and whether you notice any smell of gas or scorching — with a code, that is where the diagnosis begins.